Hw 130 Motor Control Shield For Arduino Datasheet Better |top| Today

However, the HW-130 shield’s PCB trace width and connector ratings reduce this to:

A: No. It is a clone of Adafruit Motor Shield V1 and is only compatible with the Adafruit Motor Shield V1 Library . hw 130 motor control shield for arduino datasheet better

| Feature | Specification | | :--- | :--- | | | L298N (ST) | | Operating Voltage | Logic: 5V | Motor Power: 7V – 12V (Recommended), Max 24V | | Output Current | 2A per channel (Max), 1A continuous recommended | | Peak Power | 25W | | Driven Motors | 2x DC Motors OR 1x Stepper Motor (4-wire) | | Protection | Built-in 4x 1N5819 High-speed Schottky Diodes (Back EMF) | | Size | Standard Arduino Shield Dimensions | However, the HW-130 shield’s PCB trace width and

The shield is easy to use, but users consistently report that it draws its logic power directly from the Arduino's 5V pin. This can cause instability if you try to power two servos and heavy motors from the same battery. The most stable setups involve separate power sources for the Arduino's logic and the motors. This can cause instability if you try to

The (often referred to as the L293D Motor Shield) is a popular, low-cost driver for small motors. It is based on two L293D motor driver ICs and a 74HC595 shift register to minimize the number of Arduino pins used. Key Specifications