Control User Manual _verified_ - V2000-c Rfid Access

Sets the authentication method to require either a valid card OR a valid PIN code for entry.

Connect Power Supply (GND) to Keypad GND and Lock (-). V2000-c Rfid Access Control User Manual

If you forget the Master Code or wish to completely wipe the device settings, follow these steps: Turn off the power to the unit. Press and hold the # key while turning the power back on. Release the # key after hearing two short beeps. Sets the authentication method to require either a

: The V2000-C is a NON-PoE device. Do not connect the device to a PoE capable Ethernet port as this may cause permanent damage. Press and hold the # key while turning the power back on

| Symptom | Possible Cause | Solution | |:--------|:---------------|:---------| | No power / LEDs off | Power supply issue | Verify DC 12V and polarity | | Reader doesn't read cards | Card type mismatch | Ensure EM 125kHz card compatibility | | Buzzer continuously beeps | Anti-tamper triggered | Check cover is properly secured | | Access denied despite valid card | Access mode mismatch | Check if system requires Card+PIN | | Memory full when adding card | User capacity reached (1000 users) | Delete unused users before adding |

You can configure how users authenticate themselves to gain entry. In programming mode, press 3 + 0 + # .