Used to increase or decrease values.
Check if the "OUT" light is blinking. If it is, the controller is sending a signal, but your heater or SSR may be faulty. xmtg-2000 temperature controller manual pdf
What (K-type thermocouple, Pt100, etc.) are you using? Used to increase or decrease values
However, if you have just installed a new unit or are trying to troubleshoot an existing one, you know that programming it without the instructions can be a headache. Button combinations aren't always intuitive, and parameter codes can be cryptic. the controller is sending a signal
Wire the controller and bring the system near your typical operating environment. Set your desired target temperature (). Access the menu and locate the AT (Auto-Tuning) parameter. Change the value from 0 (Off) to 1 (On).