| Code | Meaning (Old Manual) | Meaning (Updated Manual) | Solution | | :--- | :--- | :--- | :--- | | | Overcurrent | Phase imbalance on input | Check wall outlet voltage. Requires 220V ±10%. Use a multimeter. | | E-07 | Sensor fail | Hall effect sensor gap >2mm | Remove the side cover. Push the sensor bracket toward the magnetic ring until gap is 1.2mm. | | E-12 | Temp high | Motor winding >130°C | Stop for 45 minutes. Do not just reset; clean the cooling fins. | | E-19 | Brake error | DC injection voltage low | Replace the bridge rectifier (Part #40268-19). Do not run until replaced. | | F-03 | (Not listed) | Feed roller slip | Increase pressure spring tension to setting #4. |
Carefully insert the chain into the drive socket and ensure it rides smoothly within the channel of the guide bar. Tensioning: woodzig model 40268 manual updated
Woodzig Model 40268 is an electric pole pruner commonly used for overhead branch trimming. While the manufacturer (formerly under the Oregon/Blount brand family) has phased out certain legacy lines, you can still maintain and operate the tool safely with this updated guide based on current best practices for Woodzig units. 1. Assembly & Chain Installation Remove Tensioner Plate: Unscrew the tensioner plate screw and remove the plate. Chain Direction: | Code | Meaning (Old Manual) | Meaning
Ensure the guide bar groove is clean and the oil hole is open. | | E-07 | Sensor fail | Hall
Q: What are the technical specifications of the Woodzig Model 40268? A: Review the technical specifications section in the manual for detailed information on device dimensions, weight, performance metrics, and more.